Filter
Top Products
43
620-7921 Rev A
Step 22.
Connect the seven-pin interface cable from the
console to J14 connector on the display board.
Step 23.
Now connect the iPod® cable from the bottom
cover to J10 connector on the center console
board.
Step 24.
Next replace the bottom cover. Use the screws
saved from the earlier step to secure the display
bottom. Tighten the screws so they are snug,
then plug in the CSAFE power cable to the back
of the display.
Note: Take special care to not pinch any of the ca-
bles between the plastics.
Step 21.
Connect the center console keypad cable to J8
connector on the display board.