Filter
Top Products
Service Manual: E-TR and E-TRi
44
8. The ‘Device’ – ‘Options’ window will appear
with several tabs.
LOCK BITS - Uncheck all:
FUSE BITS – Check “SUT0 Fuse” only
FUSE BITS HIGH – Check “CKOPT
Fuse” and “JTAG Fuse” only.
FUSE BITS EXTENDED – Uncheck all.
9. Once all check boxes are set as above, click
‘OK’ to finish and close window.
10. Click on ‘Load Fisp’ to send software to the
uploader.
11. You will see a Transferring Date” status
window. Click ‘Close’ when prompted.
12. This will complete the programming of the
Primary uploader. Return to the Project
Change Point to complete the Secondary
uploader.
. RETURN TO PROJECT CHANGE POINT .
13. Use a sticker or tape and mark each
uploader as “Primary” or “Secondary”. It is also
a good idea to put the version of software and
which model it if for. You can update them
when updating software versions for future
uses.