Filter
Top Products
Service Manual: E-TR and E-TRi
14
RUNNING BELT
Once a deck surface has been used, it should not be used again.
You must install a new belt and new deck surface together. Most Star Trac decks are double-sided
so they can be flipped to utilize both sides. Failure to install a new belt over a fresh deck surface will
cause the belt to burn along the center walking area, the edges will curl, electrical components will
create so much heat as to begin to fail, and will not be covered under warranty.
The Pro Tread models 7600 and 7700 are equipped from the factory with a “Waxless” running belt
and deck system. It is not necessary to regularly wax, rewax or lubricate the running belt and deck
on these models. Wax may be applied to alleviate running belt noise (see waxing instructions).
During a non-belt and/or deck related service, if a running belt and/or deck are removed, it may be
acceptable to re-install the belt and deck as long as no visible signs of wear are present or the
situation does not require replacement.
If replacing a deck due to wear, it is advisable to replace the running belt as well, because wear is
commonly caused in conjunction with the running belt.
If you have questions on whether or not to replace a running belt and/or deck, contact Star Trac
Customer Support.