Filter
Top Products
Service Manual: E-TR and E-TRi
18
RUNNING BELT RETENSION PROCEDURE
Fig 1
Step 1: Release tension of running belt by
unscrewing the tension screws until the roller
touches the finger-guard. The belt should be
completely relaxed.
(Note: This applies to both left & right finger-
guards.)
Fig 2
Step 2: Apply a piece of masking tape on the
edge of the running belt on both sides.
Fig 3
Step 3: Draw a line on each piece of masking
tape aligned with the edge of the deck.
(Note: Be careful not to move the belt or roller
while drawing the lines.)