Filter
Top Products
6300/6310 Treadmill Electronics Repair Manual – Motor
6300/6310 Motor Integrity and OHM Test Configuration
6300/6310 Motor Integrity Test Procedure
Remove the M+ M- wires from the drive board. Put multimeter to the 200 VDC setting. Place one probe on
the M+ wire. Place the other probe on the M- wire. Spin the motor flywheel with your hand. Normal results:
The faster the motor spins, the more voltage is produced. If no voltage is produced, replace the motor.
6300/6310 Motor OHM Test Procedure
Remove the M+ M- wires from the drive board. Put multimeter to the OHM setting. Place one probe on
the M+ wire. Place the other probe on the M- wire. Normal reading: 1 to 4 Ohm. Turn the flywheel slightly
and take another reading. Take readings in small steps until the flywheel completes a full rotation. All
readings
should be within 1 to 4 Ohm. “0” would indicate a short; OL would indicate a break; Replace the motor.
MOTOR.04