Filter
Top Products
6300/6310 Treadmill Electronics Repair Manual – 6310 Introduction
KPH/MPH, Distance/Time, Clear
Set MPH/KPH: Turn on the unit. “SPORTSART” scrolls across the main window. “6310” appears in the lower part of the main
window. Hold the CHANGE key down three seconds. “PRESS TO SELECT MPH/KPH, PRESS ENTER” scrolls
across the top part of the main window. “MPH” or “KPH” appears on the lower part of the main window. Press <▲> and
<▼> keys to toggle between MPH and KPH. When your choice appears, press the ENTER key to confirm your selection.
See Distance/Time: “PRESS ▲▼ TO SELECT MODIFY HRC TARGET HR (Y/N)?, PRESS ENTER” scrolls across
the top part of the main window. “NO” or “YES” appears on the lower part of the main window. Press <▲> and <▼>
keys to toggle between “no” and “yes”. Select your choice. Press ENTER key to continue.
Distance: A four-digit number appears over the word “MILE” (KM if in metric mode). “TOTAL DISTANCE” scrolls
across the main window. This is the distance of unit operation. Press ENTER key to continue.
Time: A four-digit number appears over the word HOUR. “TOTAL TIME” scrolls across the main window. This is the
total time of unit operation. Press ENTER key to continue.
Start Up: Unit enters start up mode. “SPORTSART” scrolls across the top part of the main window. “6310” appears in
the lower part of the main window.
To Clear Time/Distance: In start up mode, press STOP/PAUSE and ENTER keys for one second. “PRESS ▲▼ TO
SELECT CLEAR TOTAL DISTANCE & TIME (Y/N)?, PRESS ENTER” scrolls across the top of the main screen.
“NO” or “YES” appears on the bottom of the main screen. Press <▲> <▼> keys to select “YES” to delete the time and
distance or select “NO” to preserve the present distance/time memory. Press ENTER key to confirm your choice.
6310 INTRO.09