Filter
Top Products
Page 47 of 75
intelligent wireless platform
airClient™ TOTAL 3415 User Guide
Adding and deleting static routes is allowed in the Router Mode of the airClient TOTAL
.
Follow the steps below to add a static route entry in the airClient TOTAL operating in the Router Mode.
1. Click on Networking | Routing Table from the menu bar to access the routing table page.
2. Enter the Destination IP, IP Mask, Gateway for the new route. Select Add to add a new route as
shown in Fig 2-33.
3. Select the Status to activate or deactivate the static route.
4. Click on Tools | Reboot to reboot the unit. The new routes will be activated or deactivated after
the Reboot.
5. Upon the reboot, the total number of entries in this Routing Table will show up in Summary
Information page as shown in Fig 2-34 below.
Figure 2-33 airClient TOTAL Add Static Route in Routing Table
Figure 2-34 Static Route Entries on Summary Page