Filter
Top Products
20
www.seuservice.com
7. EXPLANATION OF TEST AND DATA DISPLAY
By operating the switch unit, periodically perform the tests and data check. When installing the
machine initially or collecting cash, or when the machine does not function correctly, perform
checking in accordance with the explanations given in this section. The following shows tests and
modes that should be utilized as applicable.
CAUTIONS TO BE HEEDED WHEN USING THE TEST MODE:
In the case where plural machines are linked for communication play, if even one seat enters the test
mode, all of the linked seats will enter the test mode. Therefore, if anyone of the linked machines is
in play, use care so as not to use the test mode.
The contents of the setting changes made will made will not be effective unless the test mode is
finished in the test mode. When the setting is changed, be sureto “EXIT” in the menu mode. Do not
press the TEST BUTTION during network check at the time of turning the power on or exiting from
the test mode. If anyone of the linked machines uses the test mode during network check, all other
Seats will continue network checking. Cause all of the Seats to reenter the test mode and then have
all of the Seats exit from the test mode simultaneously.
TABLE 7 EXPLANATION OF TEST MODE
ITEMS
INSTALLATION
OF MACHINE
MEMORY
PERIODIC
SERVICING
CONTROL
SYSTEM
MONITOR
IC BOARD
DATA CHECK
DESCRIPTION
When the machine is installed, perform the following:
1. Check to see that each setting is as per standard setting
made at the time of shipment.
2. In the INPUT TEST mode, check each SW and VR.
3. In the OUPUT TEST mode, check each of lamps.
4. In the MEMORY TEST mode, check ICs on the IC Board.
Choose MEMORY TEST in the MENU mode to allow the
MEMORY test to be performed. In this test, PROGRAM
RAM’s, ROM’s, and ICs on the IC Board are checked.
Periodically perform the following:
1. MEMORY TEST
2. Ascertain each setting.
3. In the INPUT TEST mode, test the CONTROL device
4. In the OUTPUT TEST mode, check each of lamps.
1. In the INPUT TEST mode, check each SW and VR.
2. Adjust or replace each SW and VR.
3. If the problem can not be solved yet, check the
CONTROL’S moves.
In the MONITOR ADJUSTMENT mode, check to see if the
MONITOR adjustment is appropriately made.
1. MEMORY TEST
2. In the SOUND TEST mode, check the sound related ROMs.
Check such data as game play time and histogram to adjust the
difficulty level, etc.
SECTIONS
7 - 10, 7 - 11
7 - 6
7 - 7
7 - 3, 7 - 4
7 - 3, 7 - 4
7 - 10, 7 - 11
7 - 6
7 - 7
7 - 6
8
12
7 - 2
7 - 8
7 - 15