Filter
Top Products
30
SYMPTOM: The walking belt is off-center or slips
when walked on
a. If the walking belt is off-center, first adjust incline
to 40 percent. Remove the key and UNPLUG THE
POWER CORD. If the walking belt has shifted to
the left, use the hex key to turn the left idler roller
screw clockwise 1/2 of a turn; if the walking belt
has shifted to the right, turn the left idler roller
screw counterclockwise 1/2 of a turn. Be careful
not to overtighten the walking belt. Then, plug in
the power cord, insert the key, and run the incline
trainer for a few minutes. Repeat until the walking
belt is centered.
b. If the walking belt slips when walked on, first
adjust incline to 40 percent. Remove the key and
UNPLUG THE POWER CORD. Using the hex key,
turn both idler roller screws clockwise, 1/4 of a
turn. When the walking belt is correctly tightened,
you should be able to lift each edge of the walking
belt 3 to 4 in. (8 to 10 cm) off the walking platform.
Be careful to keep the walking belt centered. Then,
plug in the power cord, insert the key, and care-
fully walk on the incline trainer for a few minutes.
Repeat until the walking belt is properly tightened.
SYMPTOM: The iFit Live mode does not function
correctly
a. If the iFit Live mode is not functioning correctly,
make sure that the incline trainer has the most cur-
rent firmware available (see step 3 on page 24).
SYMPTOM: The incline trainer will not connect to
the wireless network
a. Make sure that the wireless settings on your con-
sole are correct (see step 4 on page 25).
b. Make sure that the settings for your wireless net-
work are correct.
c. If you still have questions, see the front cover of
this manual.
a
b