Filter
Top Products
11
9. Attach the Console Base Back (89) to the
Console Base (87) with nine #8 x 3/4" Machine
Screws (16) and two #8 x 3/4" Screws (1) in
the locations shown. Start all eleven Screws,
and then tighten them. Do not overtighten
the Screws. Make sure that no wires are
pinched.
9
16
16
16
16
16
1
1
89
87
8. Hold the left handrail assembly (C) near the left
Upright (77). Insert the pulse wire from the left
handrail assembly into the hole in the top of the
Upright and out of the end of the Upright.
Set the left handrail assembly (C) onto the left
Upright (77). Make sure that no wires are
pinched. Attach the left handrail assembly with
two 3/8" x 5 1/2" Screws (5) and two 3/8" Star
Washers (8). Note: Start the lower Screw first.
Insert the pulse wire through the three ties (only
two are shown). Connect the two “L” pulse wires
(see also step 7).
L
R
R
L
8
C
Ties
Tie
77
5
8
Pulse
Wire
Start First