Filter
Top Products
29
Locate the Reed Switch (55) and the Magnet (41)
on the left side of the Pulley (42). Turn the Pulley
until the Magnet is aligned with the Reed Switch.
Make sure that the gap between the Magnet
and the Reed Switch is about 1/8 in. (3 mm). If
necessary, loosen the #8 x 3/4" Clamp Screw (20),
move the Reed Switch slightly, and then retighten
the Screw. Reattach the Left Roller Cover (not
shown) and run the incline trainer for a few minutes
to check for a correct speed reading.
SYMPTOM: The incline of the incline trainer does
not change correctly
a. Calibrate the incline system (see step 4 on page
24).
SYMPTOM: The walking belt slows when walked on
a. Use only a single-outlet surge suppressor that
meets all of the specifications described on page
14.
b. If the walking belt is overtightened, incline trainer
performance may decrease and the walking belt
may become damaged. Remove the key and
UNPLUG THE POWER CORD. Using the hex
key, turn both idler roller screws counterclockwise,
1/4 of a turn. When the walking belt is properly
tightened, you should be able to lift each edge of
the walking belt 3 to 4 in. (8 to 10 cm) off the walk-
ing platform. Be careful to keep the walking belt
centered. Then, plug in the power cord, insert the
key, and run the incline trainer for a few minutes.
Repeat until the walking belt is properly tightened.
c. Your incline trainer features a walking belt coated
with high-performance lubricant. IMPORTANT:
Never apply silicone spray or other substances
to the walking belt or the walking platform un-
less instructed to do so by an authorized ser-
vice representative. Such substances may de-
teriorate the walking belt and cause excessive
wear. If you suspect that the walking belt needs
more lubricant, see the front cover of this manual.
d. If the walking belt still slows when walked on, see
the front cover of this manual.
42
41
1/8 in.
Top
View
20
3–4 in.
b
Idler Roller Screws
55