Filter
Top Products
24
HOW TO USE THE MAINTENANCE MODE
The console features a maintenance mode that al-
lows you to update the console firmware, calibrate the
incline of the incline trainer, calibrate the screen, view
technical information, and view a button’s keycode.
1. Select the settings main menu.
See step 1 on page 23.
2. Select the maintenance mode.
In the settings
main menu,
touch the
Maintenance
button to enter
the mainte-
nance mode.
The maintenance mode main screen will show
information about the model and version of the in-
cline trainer.
3. Update the console firmware.
For the best results, regularly check for firm-
ware updates.
Touch the Firmware Update button to check for
firmware updates using your wireless network. The
update will begin automatically.
To avoid damaging the incline trainer, do not
turn off the power or remove the key while the
firmware is being updated.
Note: Occasionally, a firmware update may cause
your console to function slightly differently. These
updates are always designed to improve your exer-
cise experience.
Note: If you cannot update the console firmware
over your wireless network, you can update the
firmware using a USB drive. Go to www.iFit.com
and download the latest firmware update onto your
USB drive. Safely remove the USB drive from your
computer and plug it into the USB port on the side
of the console. The update should begin
automatically.
The screen will show the progress of the update.
When the update is complete, the incline trainer
will turn off and then turn back on. If it does not,
press the power switch into the off position. Wait
for several seconds, and then press the power
switch into the reset position. Note: It may take a
few minutes for the console to be ready for use.
4. Calibrate the incline system of the incline
trainer.
Touch the Calibrate Incline button. Then, touch the
Begin button to calibrate the incline system. The in-
cline trainer will automatically rise to the maximum
incline level, lower to the minimum incline level,
and then return to the starting position. This will
calibrate the incline system. Press the Cancel but-
ton to return to the maintenance mode. When the
incline system is calibrated, touch the Finish
button.
IMPORTANT: Keep pets, feet, and other objects
away from the incline trainer while the incline
system is calibrating. In an emergency, pull the
key from the console to stop the incline
calibration.
5. View machine information.
Touch the Machine Info button to view information
about your incline trainer. After you view the infor-
mation, touch the back button on the screen.
6. Find Keycodes.
This option is intended to be used by service tech-
nicians to identify whether a certain button is work-
ing correctly.
7. Exit the maintenance mode.
To exit the maintenance mode, press the back but-
ton on the console.
Start Workout