Filter
Top Products
OPERATION
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
Treadmill Will Not Start.
Treadbelt Does Not Run In
Center Of Roller.
Treadbelt Slips While In Use.
Treadbelt Hesitates When
Stepped On.
Treadmill Makes "Rumbling"
Noise.
Treadmill Makes "whining"
Noise.
Treadmill Is DifficultTo Roll.
Black Particles Collecting
Under Treadmill.
No Display On Fitness
Computer in Console.
Fitness Computer Does Not
Display Speed Or Distance.
Fitness Computer Shuts Off.
No Pulse Displayed On
Fitness Computer.
OPERATION TROUBLE-SHOOTING
il. ! Not Plugged In.
i2.[
House Circuit Breaker
Tripped.
3. Treadmill Reset Switch
Tripped.
4. Unit Plugged Into Insufficient
Extension Cord.
5. Inadequate Voltage At Outlet.
1. Treadbelt Tension Not Even
Across The Treadbelt.
1. Treadbelt Tension Too Light.
1. Insufficient Lubricant On
Treadbelt.
1. Treadbelt Tensioned Too
High.
1.
Walking Too Close To The
Edge Of Treadbelt.
1. Treadmill On Thick Carpeting.
1. Drive Belt Is Breaking In.
1. Treadmill Not Plugged In
And Power Key Not Inserted
Into Console.
1. Reed Switch Not Aligned
Properly.
1. Magnet Damaged Or Missing
From Pulley on t-ront Roller.
2. Reed Switch Not Working
Properly.
! 3. Fitness Computer Not
[ Working Properly.
21 Pulse Earclip Not Plugged
Into Console.
Pulse Earclip Not Properly
Attached To Earlobe.
3.
4.
Pulse Earclip In Direct
Sunlight
Pulse Earclip Is Moving
Around Too Much.
Plug Into Three Prong (grounded)
115/120 Volt-60 Hz AC Outlet - See
Treadmill Grounding.
Reset Or Replace Fuse.
Reset Treadmill Reset Switch.
Plug Directly Into Wall Outlet Or
Use Short (less Than Ten Feet),
Heavy Gauge (t4 Gauge Or Better)
Extension Cord.
Have Qualified Electrician Check
Voltage.
See - "Treadbelt Adjustment" on
page 17.
See - "Treadbelt Adjustment" on
page 17.
See "Maintenance" on page 18.
Loosen Treadbelt Ad ustment Bolts
Till Noise Ceases But Treadbe t
Does Not Slip While In Use.
Bring Stride Back Towards Center
Of Treadbelt.
Move To Hard Surface Or Low Cut
Carpeting.
Vacuum Under Treadmill
Periodically
Plug IntoThree Prong (grounded)
115/120 Volt-60 Hz AC Outlet - See
Treadmill Grounding. Insert Power
Key. Adjust Treadbelt Speed
greater than 0 mph.
See -"Reed Switch Adjustment" on
page 17.
Replace Magnet.
Replace Reed Switch.
i 3. I Replace Fitness Computer.
r 1. ! Plug Pulse Earclip Into Back of
t
i Console.
2. Massage Earlobe To Increase
Circulation And Reattach Pulse
Earclip.- See "Using The Pulse
3. I Earclip" On Page 7.
Place Pulse Earclip On Earlobe
. I Away From Direct Sunlight.
I 4. Use Strain Relief Clip And Try Not
I To Move Head Erratically - See
DETAIL "B" On Page 7.
IF OTHER PROBLEMS ARE ENCOUNTERED OR ANY PROBLEMS CAN NOT BE CORRECTED, PLEASE
CALL OUR SERVICE DEPARTMENT TOLL FREE AT 1-800-473-7247.
8