Filter
Top Products
MAINTENANCE
Your CONCOURSE TREADMILL should require little actual maintenance other than periodically applying LUBRI-
CANT under the TREADBELT. Adequate lubrication of the TREADBOARD surface under the TREADBELT will
ensure superior performance and extend its life expectancy.
How To Check TREADBELT For Proper Lubrication:
1. Lift one side of TREADBELT and feel the top surface of the TREADBOARD.
2. If the surface is wet (slick) to the touch, then no further lubrication is required.
3. If the surface is dry to the touch, apply one packet of LUBRICANT.
How to apply LUBRICANT:
1. Lift one side of the TREADBELT.
2. Pour one entire LUBRICANT packet under the center of the TREADBELT on the top surface of the TREAD-
BOARD.
3. Walk on TREADMILL at slow speed for 3 to 5 minutes to evenly distribute LUBRICANT.
NOTE: Do not over-lubricate TREADBOARD. Excess LUBRICANT may come out from underthe TREADBEL T.Any
excess LUBRICANT on the TREADBOARD should be wiped off.
Lubrication Schedule:
If the TREADMILL is used at low speeds, the TREADBELT will not need to be lubricated as frequently; while high
speed use may require more frequent lubrication.If the TREADBELT does not maintain speed during useor hesitates,
lubrication may be required. The following lubrication schedule is only a guideline based on average TREADMILL
use:
1. After the first 25 hours of use (2-3 months), apply one LUBRICANT packet.
2. Every 50 hours of use (5-8 months), apply an additional LUBRICANT packet.
Two LUBRICANT packets are included with the TREADMILL. Additional LUBRICANT can be ordered in packs of
ten, using the form below.
LUBRICANT ORDER FORM
10 packets - 1/3oz ea.
NAME: MAIL TO:
ADDRESS:
Diversified Products Corporation
P.O. Box 100
Openka, AI 36803
Attn.: Customer Service
Include check or money order for $9.95. Checks should be made out to Diversified Products.
AMOUNT ENCLOSED:
18