ProForm 485CX Treadmill User Manual


 
7
2. With the help of a second person, carefully tip
the treadmill onto its right side. Partially fold the
F
rame (58) so the treadmill is more stable. D
o
not fully fold the treadmill until it is com-
p
letely assembled.
Insert the other Extension Leg (89) into the base
of the Uprights (84) as shown. Next, insert two
Extension Leg Bolts (64) with two Star Washers
(8) into the bottom of the Extension Leg, and
firmly tighten the Extension Leg Bolts.
.
Attach two Base Pads (82) to the base of the
Uprights (84) with two 1" Tek Screws (22).
With the help of a second person, carefully raise
the treadmill so that all four Base Pads (82) are
on the floor and the Uprights (84) are in a verti-
cal position.
58
8
64
2
3. Lay the Left Handrail (103) on the floor. Slide
the left end of the Crossbar (20) onto the tab on
the Left Handrail and start two #8 x 3/4" Screws
(19) into the Crossbar and the tab. Do not
tighten the Screws yet.
Slide the tab on the Right Handrail (104) into the
right side of the Crossbar (20) and start two #8 x
3/4" Screws (19) into the Crossbar and the tab.
Do not tighten the Screws yet.
20
3
89
8
2
82
22
19
103
104
19
Tab
Tab
4. Have a second person hold the Handrails (103,
104) near the Uprights (84). Insert the Upright
Wire Harness (77) through the large holes in the
Right Handrail as shown.
Next, set the Handrails (103, 104) on the
Uprights (84).
Do not let the Upright Wire
Harness (77) fall into the Right Handrail.
Attach the Handrails (103, 104) to the Uprights
(84) with four Handrail Bolts (64) and four Star
Washers (8); start all four Handrail Bolts but
do not tighten them.
84
103
104
8
8
77
64
84
64
4
84
Large Holes