Filter
Top Products
10
13. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking
belt (see page 27). To protect the floor or carpet, place a mat under the treadmill.
12. Raise the Shock (92) to a vertical position.
Remove the Shock Pin (25) from the raised end
of the Shock as described in step 11. If neces-
sary, rotate the Shock to align the end of the
Shock with the ball on the bracket on the Frame
(58).
Next, press the Incline increase and decrease
buttons until the ball on the bracket is aligned
with end of the Shock (92). Then, press the end
of the Shock onto the ball. Note: It may be nec-
essary to press the end of the Shock onto the
ball while the Frame is moving.
See drawing 12a. Insert the Shock Pin (25) into
the two indicated small holes in the end of the
Shock (92). Then, rotate the Shock Pin until it
clips onto the Shock. Note: Extra Shock Pins
are included.
Press the Incline decrease button until the
treadmill is at the lowest incline level. Then,
unplug the power cord and lower the treadmill
Frame (58) to the floor.
25
92
Holes
25
92
12
12a
58
Bracket
11. Place the treadmill in the storage position (see
HOW TO FOLD AND MOVE THE TREADMILL
o
n page 24).
N
ext, place the cylinder end of the Shock (92)
near the bracket on the base of the Uprights
(84).
See the two small inset drawings. Using your
fingernail or the end of a screwdriver, press on
the end of the Shock Pin (25) to loosen it from
the Shock (92). Next, rotate the Shock Pin and
pull it out of the Shock.
Be careful to avoid los-
ing the Shock Pin.
See drawing 11a. Press the cylinder end of the
Shock (92) onto the ball on the bracket. Next,
insert the end of the Shock Pin (25) through two
of the small holes in the end of the Shock. Then,
rotate the Shock Pin until it clips onto the Shock.
9
2
25
92
2
5
11
11a
8
4
Bracket
Cylinder
Bracket
2
5
25