ProForm 485CX Treadmill User Manual


 
HOW TO USE AN IFIT.COM PROGRAM DIRECTLY
FROM OUR WEBSITE
Our website at www.iFIT.com allows you to access
p
rograms directly from the internet. Additional options
are soon to be available. See www.iFIT.com for details.
To use programs from our website, you must connect
the treadmill to your home computer. See HOW TO
CONNECT YOUR COMPUTER on page 19. In
addition, you must have an internet connection and
an internet service provider. A list of specific system re-
quirements is found on our website.
Follow the steps below to use a program from our
website.
1.
Insert the key into the console.
See HOW TO TURN ON THE POWER on page 13.
2.
Select the iFIT.com mode.
See step 2 on page 20.
3.
Go to your computer and start an internet
connection.
4.
Start your web browser, if necessary, and go to
our website at www.iFIT.com.
5.
Follow the desired links on our website to se-
lect a program.
Read and follow the on-line instructions for using a
program.
6.
Follow the on-line instructions to start the
program.
When you start the program, an on-screen count-
down will begin.
7.
Return to the treadmill and stand on the foot
rails. Find the clip attached to the key and slide
the clip onto the waistband of your clothes.
When the on-screen countdown ends, the program
will begin and the walking belt will begin to move.
Hold the handrails, step onto the walking belt, and
begin walking. During the program, an electronic
chirping” sound will alert you when the speed
and/or incline of the treadmill is about to change.
C
AUTION: Always listen for the “chirp” and be
prepared for speed and/or incline changes.
If the speed or incline settings are too high or too
low, you can manually override the settings at any
time by pressing the Speed or Incline buttons on
the console. However, when the next “chirp” is
heard, the speed and/or incline will change to
the next settings of the program.
To stop the walking belt at any time, press the Stop
button on the console. The time will begin to flash
in the display. To restart the program, press the
Start button or the Speed increase button. After a
moment, the walking belt will begin to move at 2
km/h.
When the next “chirp” is heard, the speed
and incline will change to the next settings of
the program
.
When the program is completed, the walking belt
will stop. Note: To use another program, press the
Stop button and go to step 5.
Note: If the speed and/or incline of the treadmill
does not change when a “chirp” is heard, make
sure that the letters “iFIT” appear in the display
and that the time is not flashing in the display.
In addition, make sure that the audio cable is
properly connected.
8.
Follow your progress with the display.
See step 5 on pages 13-14.
9.
When you are finished exercising, remove the
key from the console.
See step 8 on page 14.
22