Filter
Top Products
23
THE INFORMATION MODE
T
he console features an information mode that keeps
track of treadmill usage information. The information
m
ode also allows you to select kilometers or miles as
the unit of measurement and to turn on and turn off the
demo mode.
To select the information mode, hold down the Stop
button, insert the key into the console, and then release
the Stop button. When the information mode is se-
lected, the following information will appear in the dis-
play:
The center of the
display will show
the total number
of kilometers or
miles that the
walking belt has
moved. The
lower part of the
display will show
the total number of hours that the treadmill has been
operated. In addition, an “M” for metric kilometers or an
“E” for English miles will appear in the lower part of the
display. To change the unit of measurement, press the
Speed increase button.
IMPORTANT: If a “d” appears in the display, the con-
sole is in the “demo” mode. This mode is intended to be
used only when a treadmill is displayed in a store.
When the console is in the demo mode, the power cord
can be plugged in, the key can be removed from the
console, and the indicators in the display will automati-
cally appear in a preset sequence; the buttons on the
console will not operate.
If a “d” appears when the in-
formation mode is selected, press the Speed de-
crease button so “d” disappears.
To exit the information mode, remove the key from the
console.
THE OPTIONAL CHEST PULSE SENSOR
An optional chest pulse sensor adds even more fea-
tures to the console. The chest pulse sensor offers
hands-free operation, and enables you to use the
console’s two heart rate programs.
To purchase the
optional chest pulse sensor, please see the dealer
contact information on the back cover of this manual
or on the included service card.
If you purchase the optional chest pulse sensor fol-
low the steps below to install the receiver included
with the chest pulse sensor.
1. Remove the key from the console and unplug
the power cord.
Remove the Screw (3) and the Access Door (76)
from the back of the Console Base (85).
2. Connect the wire on the receiver (A) to the indi-
cated wire extending from the Console Base (85).
Hold the receiver so the small cylinder is ori-
ented as shown and is facing the Console
Base. Attach the receiver to the plastic posts on
the Access Door (76) with the two included small
screws.
3. Make sure that no wires are pinched. Reattach
the Access Door (76) with the Screw (3). Discard
the other wires included with the receiver.
A
85
Small
Cylinder
3
76
Wire
Small Screws