Filter
Top Products
page 15
COMMERCIAL PRODUCTS DIVISION
8. Secure the upper handrails. Diagram 7, #1. With both handrails in place,
tighten the 2 screws in the upper handrail clamp using the hex key provided.
9. Secure the lower handrails. Diagram 7, #2. Use the supplied hex key to
tighten the 4 set screws, located on each lower handrail stub. Do not over-
tighten, as you can strip the threads on these small screws.
10. Return to the upper handrail clamp. Double check that the clamp bolts
are securely tightened.
Note: You have completed the assembly of the EFX546. To level the unit
and connect it to a power source, continue with the steps below.
11. If you need to move the EFX, ask for assistance. The EFX weighs over 200
pounds (90 kilograms). A hand cart may be useful to help move the unit.
CAUTION: A fully-assembled EFX546 is very heavy. To avoid possible
injury, Precor recommends that more than one person move the
EFX546 to its final location.
Diagram 8
Level the unit.
Rear crossbar
Rear casing
Adjustable rear foot
12. Level the unit. Diagram 8. The unit has adjustable rear feet that can help
level the unit ± 1/4". To rotate the adjustable rear feet, have an assistant
stand in front of the display console and face the rear feet. Ask the assistant
to grasp the upper handrails on either side of the display console and pull
toward him or her. The rear feet should lift off the floor which will allow you to
rotate the rubber feet in the necessary direction.
Diagram 7
Secure the handrails.
Upper clamp
Display console
1
2
Lower
handrail
stub
Set screw
Hex key