Filter
Top Products
page 12
COMMERCIAL PRODUCTS DIVISION
4. Connect the cable(s). Diagram 2. Have an assistant hold the upright column
support over the base frame crossbar opening (display console must face the
foot pedals), while you take the following steps:
a. Remove any tape that holds the cable(s) to the base assembly.
CAUTION: Keep the upright column support near the opening in
the base assembly so that the cable(s) are not stretched, crimped,
or damaged. Stretched, crimped, or damaged cables are not cov-
ered by the Precor limited warranty.
Note: If you have two sets of cables (the second set exists if the EFX
you purchased has the heart rate touch-sensitive electrode strips on the
handrails), perform the next step on one connector at a time.
b. Insert the cable into it's receptacle. Diagram 2, #1. Just like a telephone
connection, a definite "click" is heard when a good connection is made.
If you do not hear a "click," try reinserting the cable again.
c. Place the excess cable inside the base frame’s crossbar as you care-
fully, lower the upright support into the base frame’s crossbar opening.
Diagram 2, #2.
CAUTION: Do not stretch, crimp, or damage the cable. Excess cable
may be gently pushed into the upright support tube. Cables dam-
aged by improper installation will not be covered by the Precor
limited warranty.
d. Have your assistant hold the upright column support in place while you
perform step 5.
Diagram 2
Connect cable(s)
and install the
upper assembly.
Cable
Base frame
1
2
Upright column
support