Filter
Top Products
page 11
COMMERCIAL PRODUCTS DIVISION
You do not need any special knowledge or experience to set up the EFX. How-
ever, you will need assistance. Because of the size and weight of the EFX, it is
recommended that at least three adult persons assemble it.
INSTALLATION REQUIREMENTS
Follow these installation requirements when installing the EFX.
If you do not
install the EFX according to the following guidelines, you could void the Precor
limited warranty.
• Set up the EFX on a solid, flat surface. Unpack and assemble the EFX close
to where you’ll use it. Make sure that the flat surface under the unit is smooth and
level. A level unit is required for the user’s safety and for proper operation.
• Provide ample space around the unit. Open space around the unit makes
for a safer mount and dismount.
• Fill out and mail the limited warranty card. Be sure that the EFX is turned
OFF. To locate the serial number, kneel down alongside the EFX and look for
a label inside the rear cover.
Write the serial number onto the Precor limited
warranty card found on the back cover of this manual. Refer to
Obtaining
Service
on page 2 and write the number(s) there as well.
• Use the appropriate voltage, dedicated circuit, and grounding as specified
on the EFX546. The EFX546 is available in 120-volt and 240-volt models. Refer
to the identification label next to the I/O switch to determine the voltage, power
cord, and plug that your EFX546 requires. Make sure that the EFX546 is con-
nected to a power outlet that has the same configuration as the plug.
CAUTION: Use the appropriate power cord and plug for your unit. Do not
use a non-grounded outlet. Electrical damage can occur if the EFX546 is
connected to an improper power source.
ASSEMBLY INSTRUCTIONS
You do not need any special knowledge or experience to set up an EFX546, how-
ever, you will need assistance and appropriate tools. To assist you in the assem-
bly, the items in the hardware kit, shown in Diagram 1, correspond to a particular
letter in the alphabet. These letters appear throughout the assembly instructions.
Refer to Diagram 1, as needed.
1. Unpack the EFX546. Remove the packing materials and loose contents
(upper console assembly with display console, hardware kit, clamp covers,
handrails, and power cord) from inside the cardboard pockets and from around
the base frame assembly.
2. Pull the large cardboard piece away from the base frame assembly.
Ask for assistance to move the EFX546 off the shipping pallet. You may need
to cut the tie wraps that hold the base frame and roller arms to the pallet.
3. Move the unit to the location where you plan to use it. Once you attach
the handrails, the EFX is difficult to move through a standard door frame.
Make sure that you assemble the unit where it will not have to be moved
through any doorways. Verify that the EFX is unplugged and turned OFF.
Do not assemble the EFX if it is plugged into a power outlet.
Setting Up the EFX
®