Filter
Top Products
page 14
COMMERCIAL PRODUCTS DIVISION
Diagram 5
Loosen upper
handrail clamp.
Upper handrail clamp
1
2
Upright column support
6. Loosen, but do not remove, the 2 screws in the upper handrail clamp
using the supplied hex key. Diagram 5.
7. Attach the handrails one at a time. Diagram 5. Perform the following steps
on one side at a time.
a. Align the upper and lower portions of the handrail. See Diagram 5, #2.
Important: If you have purchased the Precor Heart Rate “touch” Option,
you will need to connect the cables as shown in the inset in Diagram 5, #2.
b. Insert the lower end of the handrail into the base handrail stub. See
Diagram 5, #2.
Diagram 6
Install the handrails.
Black foam grip
Upper clamp
Display console
1
2
Lower
handrail stub
Set screw
c. Slide the upper portion of the handrail into the upper clamp until the
black foam grip touches the clamp. See Diagram 6, #1.
d. Obtain 4 set screws from the Hardware kit.
e. Insert the 4 set screws as shown in Diagram 6, #2 and finger tighten.
f. Perform steps a. through e. on the opposite side.
Cable
attachment
exists for
Precor Heart
Rate “touch”
option only.