Filter
Top Products
page 30
COMMERCIAL PRODUCTS DIVISION
USER SETUP PROMPTS
Precor banner: The Precor banner and program profiles appear in the center
display. Always start a workout at the Precor banner.
Important:
Because the EFX is self-powered, the Precor banner does not appear
until the user maintains a stride rate above 40 strides per minute. Note that there is
an exception to this rule. If power is being supplied through the optional power
adapter, then pedaling is not required prior to entering a program. Refer to page 7,
EFX
®
Self-powered Features.
Setup prompts appear in the center display prior to your workout. You address
each prompt using the keypad keys.
Keypad use during
Setup Prompts Description
▼ or ▲ Scrolls through the selections. The longer the key is held
down, the faster the selections scroll past.
Select Acts the same as the Enter key.
Reset Exits the Setup Mode and returns the display to the
Precor banner.
QuickStart Bypasses any remaining Setup prompts and accesses
the program selection. Refer to
Using QuickStart During
the Setup Prompts
on the opposite page.
Enter Submits the displayed selection and moves onto the next
Setup prompt.
PROGRAM prompt: The EFX provides 5 program selections. The first program se-
lection to appear on the display is MANL (Manual program). Use any ▼▲ key to
change the selection. Press Enter to accept the displayed name. Have the user
refer to
the display label on the console to determine which abbreviations represent the
different program selections. For a description of the programs, refer to page 42.
Important: If you press QuickStart while a program selection is displayed, the
program begins. Refer to
Using QUICKSTART during the Setup Prompts
.
Note: If no key press is detected for ten seconds, the display prompts the user on
what to do next. If no key press is detected for two minutes or the RESET key is
pressed, the display returns to the banner.
Workout Time prompt: A default value of 30 minutes (or the custom settings limit,
whichever is less) appears. Use any ▼▲ key to change the workout time. For
MANL, XTR, and INTV programs, the workout time may be set as low as one
minute or as high as the custom settings limit. Press Enter or QuickStart to
accept the displayed value.