Filter
Top Products
page 12
COMMERCIAL PRODUCTS DIVISION
Route the cable and
attach the display
console to the upright
support.
Display console
Upright support
Cable
2
1
Diagram 5
5.
Prepare for the attachment of the upright support to the base assembly
.
Diagrams 5 and 6. Remove the four Phillips-head screws (D), two bolts (G),
and two washers (H) from the Hardware kit. Place one washer (H) on each of
the two bolts (G). Keep the fasteners together.
CAUTION: Do not stretch, crimp, or damage the cable. Excess cable may
be gently pushed into the base assembly. Cables damaged by improper
installation will not be covered by the Precor limited warranty.
6. Route the display console cable through the upright support. Diagram 5 , #1
Remove any tape or wire ties on the cable. Have an assistant hold the upright
support securely while you grasp the display console in one hand and route the
cable through the upright support with the other.
7. Attach the display console. Diagram 5, #2. Use the four phillips-head
screws (D) to attach the display console to the upright support. Have your assis-
tant hold the upright support securely while you align the mounting holes and
tighten the screws.
2
Diagram 4
Front base assembly.
Height adjuster
Front base tube
Tighten the height
adjuster so that the
nut is secure against
the front tube.
1
4. Thread the height adjuster to its lowest position. Diagram 4, #1 and #2.
Remove the height adjuster from the Hardware kit. Ask an assistant to lift the
front base tube while you insert the height adjuster. Turn the height adjuster so
that the threads appear inside the base tube. Tighten the nut (with a crescent
wrench) when the height adjuster is fully threaded into the front base tube.