Filter
Top Products
page 20
COMMERCIAL PRODUCTS DIVISION
e. Wrench tighten using a ⁹⁄₁₆-inch socket and open end wrench. Refer to
Diagram 15, #1.
Important: Once the fasteners are secured, use a hex torque wrench to
tighten the two linkage arm screws to 200 in-lbs.
f. Position two plastic caps (C) over the ends of the handlebar mounts. Press
them into place. Refer to Diagram 15, #2.
19. Return to the handlebar bracket fasteners. Tighten all three screws using a
½-inch socket wrench. Diagram 15, #3.
Diagram 15
Complete link arm
and handlebar
bracket assembly.
Wrench tighten
link arm assembly.
½-inch socket wrench
Handlebar bracket
3
1
2