Filter
Top Products
page 3
COMMERCIAL PRODUCTS DIVISION
• Never place your hand(s) or feet in the path of the roller arm because
injury may occur to you or damage may occur to the equipment. Refer to
Diagram 1.
• Never operate the unit if it is damaged, if it is not working properly, if
it has been dropped, or dropped in water. Return the unit to a service
center for examination and repair.
• Keep the optional power adapter cord away from heated surfaces.
• Do not operate where aerosol (spray) products are being used or where
oxygen is being administered.
• Do not use outdoors.
• Do not attempt to service the EFX yourself other than the assembly and
maintenance instructions found in this manual. Refer to
Obtaining Service
.
HAZARDOUS MATERIALS AND PROPER DISPOSAL
The EFX534i has an internal battery which must be removed before the EFX is
scrapped. The battery contains materials which are considered hazardous to the
environment. Proper disposal of the battery is required by federal law.
To remove the battery from the EFX, take the following steps:
CAUTION: Unplug the power adapter and disconnect it from
its receptacle at the rear of the EFX.
Tools required: Phillips-head screwdriver and hex wrench set.
1. Remove both the right and left rear covers from the EFX.
2. Remove the top rear cover.
3. Unplug the black and red battery wires from the circuit board.
4. Separate the circuit board from the battery by removing four screws.
5. The battery is held in place with a metal bracket. Lift the battery away from
the bracket.
6. Dispose of the battery according to the federal Hazardous Waste Regulations.
SAFETY APPROVAL
When identified with the ETL-c logo, the EFX has been tested and conforms to
the requirements of CAN/CSA-E-335-1/3-94, Safety of Household and Similar
Electrical Appliances.
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Diagram 1
Avoid injury from the roller
arm mechanism.
Front cover
Handlebar
Lower pivot roller arm
(handlebar linkage)
Ramp