Filter
Top Products
page 25
COMMERCIAL PRODUCTS DIVISION
QUICK START: Quick Start lets you bypass the Setup prompts and start your
workout immediately using the Manual course.
Default values apply.
QUICK START Default Values
Prompts Default Value
Course Manual
Time 30 minutes: Or, the Club limit whichever is less. Weight
Loss course is fixed at 28 minutes.
Weight 150 lbs. (68 kg.)
Age 0 : A valid Age must be entered to utilize the Smart Rate
®
display. If Quick Start is pressed
after
an
“
Age
”
is entered,
then the Smart Rate
®
display will appear when you grasp
the touch-sensitive electrode strips on the handrail or wear
the POLAR
®
chest strap. If no
“
Age
”
entry occurs, the Smart
Rate
®
display lights up, but no blinking sensor appears.
Note: The POLAR
®
chest strap is available through your Precor dealer. Refer to
The Heart Rate Feature
on page 30.
The Quick Start key can be pressed any time during the Setup prompts.
Default values apply after that point. See the table below:
Press QUICK START at the,... The following occurs:
Precor banner You bypass the Setup prompts and your work
out begins in the Manual course.
Course prompt The displayed course is accessed.
Note: Since a default workout time is accessed,
no progress message (such as 10% complete)
will appear on the display. The exception to this
rule is the Weight Loss Course.
Time prompt The time that appears on the display becomes
the workout time limit. Time may be set to any
value from 1 to the Club limit. If “unlimited”
workout time is allowed by the Club, you can
select it by entering 0 with the numeric key.
Weight prompt The weight that appears on the display becomes
your designated weight that the EFX uses to
compute statistics. Acceptable entries are
between 0 and 999.
Age prompt The age that appears on the display becomes
the your designated age that the EFX uses to
compute statistics. A correct age entry between
1 and 99 is very important if you plan to utilize
the heart rate characteristics of the EFX. The
Quick Start key acts the same as the Enter
key at this point because you have answered
all the Setup prompts.