Filter
Top Products
page 12
COMMERCIAL PRODUCTS DIVISION
Diagram 3
Position the console assembly
over the base frame and
connect the cable.
RJ45 Cable receptacle
Base frame support
RJ45 Cable connector
4. Attach a handlebar to one side. Diagram 2. Take the following steps:
a. Remove the 8 handlebar screws (D) from the Hardware kit.
b. Pick up a handlebar and place it onto the base. See Diagram 2, #1.
c. Align the mounting holes and insert 4 screws (D).
d. Securely tighten the screws with the hex key provided. See Diagram 2, #2.
e. Perform steps b. through d. on the opposite side.
Important: Once the handlebars are secured, use a hex torque wrench to
tighten all 8 bolts to 25 ft-lbs (300 in-lbs).
Diagram 2
Attach the
handlebars to the
base assembly.
Handlebar
Base frame
1
2
5. Position the console assembly over the base support. Diagram 3.
Remove any tape that secures the RJ45 cable. Have an assistant hold the
upper support tube over the base frame support (display console must face
the foot pedals) while you connect the cable and align the bolt holes.
CAUTION: Do not stretch, crimp, or damage the cable. Excess cable may
be gently pushed into the upper support tube. Cables damaged by im-
proper installation will not be covered by the Precor limited warranty.
6. Connect the cables. Diagram 3. Insert the cable into it's receptacle. Just like
a telephone connection, a definite "click" is heard when a good connection is
made. If you do not hear a "click," try reinserting the cable again. Place the
excess cable inside the upright support tube.
Upright support tube
Align curved edge
on base assembly
with handlebar’s
curved edge.