Filter
Top Products
page 13
COMMERCIAL PRODUCTS DIVISION
7. Secure the console assembly to the base frame support. Diagram 4.
Place a washer (B) on each of 4 screws (A). Align the mounting holes and
insert the screws through the upper and lower bracket. Use the hex key
provided to alternately tighten each screws until all four screws are secure.
Important: Once the upper console assembly is secured, use a hex torque
wrench to tighten all 4 bolts to 140 in-lbs.
Diagram 4
Secure the console assembly
to the base frame.
Base support
Screws (A) and washers (B)
8. Install the bracket covers. Diagram 5. Remove the 2 bracket covers, the
split rubber grommet and 4 screws (C) from the Hardware kit. Then, take
the following steps:
a. Use 2 screws (C) to attach the rear bracket cover to the center tube.
See Diagram 5, #1. Tighten the screws with the hex key provided.
b. Position the split rubber grommet around the upright support tube. Slide
the grommet against the rear bracket cover to help secure it in place.
c. Use the remaining 2 screws to install the front bracket cover. Align the
mounting holes and tighten the screws. See Diagram 5, #2.
CAUTION: Do not overtighten the screws or you may inadvertently
crack the plastic covers.
Upper and lower brackets
Diagram 5
Installing the covers.
Rear bracket cover
Split rubber grommet
Upright support tube
Upright support tube
1
2
RJ45 cable
Center tube
Front bracket cover