Filter
Top Products
page 11
COMMERCIAL PRODUCTS DIVISION
You do not need any special knowledge or experience to set up the EFX.
However, you will need assistance. Because of the size and weight of the EFX,
it is recommended that at least three adult persons assemble it.
INSTALLATION REQUIREMENTS
Follow these installation requirements when installing the EFX.
If you do not
install the EFX according to the following guidelines, you could void the Precor
limited warranty.
• Set up the EFX on a solid, flat surface. Unpack and assemble the EFX close
to where you’ll use it. Make sure that the flat surface under the unit is smooth
and level. A level unit is required for the user’s safety and for proper operation.
• Provide ample space around the unit. Open space around the unit makes
for a safer mount and dismount.
• Fill out and mail the limited warranty card. Be sure that the EFX is
turned OFF. To locate the serial number, kneel down alongside the EFX and
look for a label inside the rear cover. Write the serial number onto the
Precor limited warranty card found on the back cover of this manual. Refer
to
Obtaining Service
on page 2 and write the number(s) there as well.
• Use the appropriate voltage, dedicated circuit, and grounding as speci-
fied on the EFX556. The EFX556 is available in a 120-volt and a 240-volt
model. Refer to the identification label next to the ON/OFF (I/O) switch to
determine the voltage, power cord, and plug that your EFX556 requires.
Make sure that the EFX556 is connected to a power outlet that has the
same configuration as the plug.
CAUTION: Use the appropriate power cord and plug for your unit. Do not
use a non-grounded outlet. Electrical damage can occur if the EFX556 is
connected to an improper power source.
ASSEMBLY INSTRUCTIONS
You do not need any special knowledge or experience to set up an EFX556,
however you will need assistance and certain tools. Because of its weight
and size, ask for several assistants to help you assemble the EFX556.
To assist you in the assembly, the items in the hardware kit, shown in Diagram 1,
correspond to a particular letter in the alphabet. These letters appear throughout the
assembly instructions. Refer to Diagram 1, as needed.
1. Unpack the EFX556. Remove the packing materials and loose contents
(upper console assembly with electronic console, hardware kit, bracket
covers, handrails, and power cord) from inside the cardboard pockets
and from around the base frame assembly.
2. Pull the large cardboard piece away from the base frame assembly.
Ask for assistance to move the EFX556 off the shipping pallet. You may need
to cut the tie wraps that hold the base frame and roller arms to the pallet.
3. Move the unit to the location where you plan to use it. Make sure that
the EFX556 is unplugged and turned OFF. Do not assemble the EFX556
if it is plugged into a power outlet.
Setting Up the EFX