Filter
Top Products
page 18
CHANGE: In Manual mode, the CHANGE key lets you select the feature that you want to appear on
the display. The feature remains displayed until you press CHANGE again. In other programs,
pressing the CHANGE key activates the scan function. Starting from the top of the display, each
feature is displayed sequentially and then, the course profile reappears. Note that HEART RATE
only appears if you are using the Precor Heart Rate Option.
Customizing the Display
The M9.21i or M9.21si treadmill can display speed in either miles per hour (mph) or kilometers
per hour (kph) and distance in miles or kilometers. When the M9.21i or M9.21si is shipped from
the factory, it is set to display to U.S. Standard units of measure (mph and miles). You can also
choose to turn the Smart Rate display on or off and change whether the TIME or DISTANCE
prompt appears after you choose a preprogrammed course. You can easily change an of the
settings by taking the following steps:
Note: The M9.21i or M9.21si treadmill will retain your selection even when it is turned OFF and
unplugged. You can change your selection at any time by repeating the following steps.
1. Insert the magnetic safety key into the electronic console.
2. Turn ON the treadmill using the power switch located at the front of the hood.
3. At the Precor banner, press the STOP key, followed immediately by the QUICK START key,
then the SPEED ▼ key, and lastly the SPEED ▲ key. (The numbers 3, 4, 5, 6 appear
sequentially on the display as you press the associated key.) The prompt, “PRESS ▲ FOR
MPH OR ▼ FOR KPH” appears on the display.
Important: If the QUICK START key is not pressed within 1 second after pressing the STOP
key, the display returns to the Precor banner. You will need to begin again.
4. Any ▼ or ▲ key lets you alternate between the prompts. Press one of the ▼ or ▲keys.
5. A prompt “SMART” or “NO SR” appears on the display. Any▼ or ▲ key lets you alternate
between the prompts to select whether you want the Smart Rate display to appear (SMART)
or not appear (NO SR) on the display.
6. Two messages scroll across the display: one confirms your mph or kph selection and the
other states, “PUSH ▲ FOR DISTANCE OR ▼ FOR TIME OR ‘RESET’ TO ASK.” Press the
appropriate key after answering one of the following if/then scenarios:
Note: When using a preprogrammed course (M9.21si only), you can measure your workout
by distance or time. You see the “SELECT DISTANCE” or “SELECT TIME” prompt after you
enter a course selection. The default measurement is distance.
If you want,... Then,...
your workout measured by distance press the ▲ key
your workout measured by time press the ▼ key
the option of selecting time or
distance prior to each workout press HOLD TO RESET (STOP)
After you press an arrow key, a message scrolls across the display
confirming your selection.
7. The changes have been retained in the treadmill’s memory. Continue with your workout or
turn OFF the treadmill. If you turn OFF the treadmill, be sure to store the safety key in a safe
place to prevent unauthorized use.