Filter
Top Products
page 13
11. Return to the upper handrail clamp, check to see that the foam on the handrails touches the
edge of the clamp, readjust the handrails if necessary, and
tighten the bolts securely using the
3/16" hex key (H) provided.
12. Install the water bottle cage by placing one internal star washer (E) on each of the mounting
bolts (B). Position the cage onto the mounting hole locations and insert the bolts. See
Diagram 8. Securely tighten the bolts using the 5/32" hex key ( I ). Place a water bottle inside
the cage as shown in the inset in Diagram 8.
13. Plug the treadmill into a standard 120v household outlet. Make sure that no other appliances
use the same circuit as the treadmill. If you need to move the treadmill, ask for assistance
from one or more persons. Roll the treadmill on its front wheels to the new location by lifting
the rear end of the unit.
Important: Before you can roll the treadmill on its front wheels, set the incline at 3% or more.
Follow steps 1 through 4 in
Checking the Alignment of the Running Belt,
and then, adjust the
incline to a minimum of 3%. Turn OFF the treadmill and unplug it before moving it.
14. Continue on to
Checking the Alignment of the Running Belt
to complete the installation of the
M9.21i or M9.21si treadmill.
Diagram 8
Install the water
bottle cage.
Electronic console
Water bottle cage mounting location
Water bottle cage
Bolt (B) with washer (E)
Hex key ( I )