42
FREQUENTLY ASKED QUESTIONS
What should I do if...
...
appears and the wrist unit battery must be replaced?
See the chapter Care and Maintenance for further instructions.
...I do not know where I am in the menu?
Press and hold
until the time is displayed.
...there are no reactions to any buttons?
Reset the wrist unit by pressing all the buttons simultaneously for two
seconds. Set the time and date in Basic Settings after the reset. All
other settings are saved. Skip the rest of the settings by pressing and
holding
.
...the cycling computer does not measure the calories?
Burnt calories are calculated only when you are wearing the transmitter.
...another person with a cycling computer or a heart rate monitor is
causing interface?
Consult the chapter Precautions.
...the heart rate reading becomes erratic, extremely high or shows
nil (00)?
• Make sure the wrist unit is no further than 1 m / 3 ft from
the transmitter.
• Make sure the transmitter belt has not loosened during exercise.
• Make sure the textile electrodes in sports apparel fi t snugly.
• Make sure that the electrodes of the transmitter / sports apparel are
moistened.
• Make sure the transmitter / electrodes in the sports apparel are clean
and undamaged.
• Make sure that there is no other heart rate transmitter within
1 m / 3 ft.
• Strong electromagnetic signals can cause erratic readings.
See Precautions.
• If the erratic heart rate reading continues despite moving away
from the source of disturbance, slow down your speed and check your
pulse manually. If you feel it corresponds to the high reading
on the display, you may be experiencing cardiac arrhythmia.
Most cases of arrhythmia are not serious, but consult your doctor
nevertheless.
• A cardiac event may have altered your ECG waveform. In this case,
consult your physician.
• If the heart rate measurement does not work with the sports apparel,
try measuring with WearLink strap. If your heart rate can be found
with the strap, the problem is most probably in the apparel. Please
contact the apparel retailer/manufacturer.
• If you have done all the above mentioned actions, and heart rate
measurement does not work, the battery of your transmitter may be
empty. For further information see chapter Care and maintenance.