Filter
Top Products
Step 6
A.
SlTde two hinge tabs (73) onto the wolff sleeve (39) and securely attach press seat pl:ld (49)
two 3/8 x 1" bolf;~ (97), and two 3/8" washers (78). (Note: The "hinge" part of the hinge
should face upward.)
’B.
Slide the right back pad angle (2) and left back pad angle (5) onto the wolff sleeve (39)
attach the press back pad (50) using four 3/8 x 1" bolts (97), and four 3/B" wash=:rs
C.
Secure the 1/2 x 2 x 15-1/2" plate (116) to right back pad angle (2) and the left back pad angle
using two 1/2 x 1l-1/4
~’
bolts. (87), two 1/2" washers (79), and two 1/2" low heigh! nyIock
Secure nuts, then back off 1/4 .turn.)
D.
Secure the 1/2 x 2 x 15-1/2" plate (116) fo bushing in press base (15) using 1/2 x 6- 1/ 2"
bolt (94) and one 1/2" nylock nut (82). Secure nut, then back off 1/4 turn.
E.
Apply one rubber Ibumber (56) to the back of the press back pad (50) where the .pa=~ comes
contact with the rear bolt.
10