Filter
Top Products
STEP 2
A. Screw the threaded end of the leg cable 4108) approximately 3/4" into the end of the selector
shaft (113) and tighten ]am nut securely as shown.
B.
If upon completion of assembly, the head plate 411.7) does not sit on fop of the first weight plate 467),
push the head plate clown, insert the selector pin (72) and perform several repetitions at the station.
This will relax the cable system and prevent the head plated from lifting up.
C.
If after completing step B. the head plate still does not sH on top of the first w~ight plate or if
there is excess slack in the cable system, adiust the threaded end of the cable accordingly and
refighten the iam nut,
Shroud Assembly Instructions
Use tthis procedure $o assemble the shrouds of the ParoBody 950ST
Securely assemble th~ pec station shroud (51) to"
the pec guid.e,, rod support 44.:3) and the base (15) using
four 3/8 x 1 black button head cap screws 459).
¯ (No~e: The pec station shroud has no
3/I] X 1"