Filter
Top Products
STEP 9-A
STEP 9-B ~
STEP g
A.
Slide two hinge tabs; (73) onto the leg frame (14) and securely attach leg scat pad (4T) using
3/8 x I" bolls (97), and two 5/B" washers (TB). (Nole: The "hinge" part of the hinge tab should
face downward.)
B. Atiach $wo roller p.a, ds (19) to the leg frame (14) u(s;;~ one 16-3/~".roller pad shaft ,’,27),
plastic washers (55,1 and two 3/4" starlock, collars
as shown
SEE NOTE
318 X
3/B x %" ]~TTN
frame (14) using
STEP 10
A.
Attach leg back pad ad|ust (11), and leg back pad support (12) to the
one 1/2 x S-l/?-" bolt (92), two 1/2" flange bearings (69) and one 1/2" low height lock nut
as shown. (Note: Securely tighten, then back nut off 1/4 turn to allow the two pa~’ts to’
rotate ireely.)
B. Securely attach fl~e leg back pad (48) to the leg back pod adiust (11), and leg back
to Jh eg frame 14) using .two ~/
(66), one 3/£’ tapped axle (76),
ack lock she~s ~86), one two 3/~
bu~on head cop screws
~E= ~ ~’P ~RE~S ~T~ ~~ AT THE S~E T~ ~ ~ ALLEN
D.
Securely aflach rubber bumper (56) between con~act point of leg curl/extension (B) and
frame ~14) a~ s;hown.