Filter
Top Products
STEP 1
A.
\
3/B X 2-3/4
°
Leg Station Cable Assembly Instructions
Use this procedure to assemble the leg .station cable of the PARABOD¥ 950 S’T
Route the "loop" end of the leg cable (lOB) into the rear sl,}t of the leg weight stack base (I"B)
behind the welght stack, and out through the slot near the leg station.
Securely attach the "loop" end of the.leg cable (lOB)., to the cam on the leg ¢url/e×’ienslon
using one 3/8 x 1" bolt (97), two 3/8" washers (78), and one 3/8" nylock
Secure the leg cable= ~108) and one 3-1/2" pulley ~111) to the pulley flat on the leg f~’ame
using one 3/8 x 2-1/4" .~,pIt (119), on~ 2-3/B ’L’ bracket (75), three 3/B" washers (;~B), one
spacer (120), and one 3/B nylock nut (83). (Note: The leg cable should be routed underneath
shah leg of the ’L’ bracket and over the top of the pulley. Also the ’L’ brackef should be positioned
af a 45 degree ang~e to function properly.)
Secure the leg cabl~= (IOB~ ~nd ~o 3~/2" pulleys (111). ~o the leg weight stack base (1B)
two 3/s x 2-3/4" I)olts (99), four 3/8 flange spacers (74), and two 3/B" nylock nuts .(B3).
Loop cable under the pulley prior to Inserting it into the slot.)
Secure the leg cable (108) and one 3-1/r pulley II11) to
~~~ L
ie~ ~uide rod sunno~ (25) ~inn on~ ~/~.x 2-$/~" bolt
two 3/8" flange spacers (74), and one 5/8" nylock nut
(Nofe:-Loop the cable over the pulley prior to.inseding it in
3/8 X ~-3/