Filter
Top Products
Pec Dec Cable Assembly Instructions
Use this procedure to assemble the pec dec cables of the ParaBody 950ST
Step C
Step F & H
Step G
I
1318 x ~-3/4."
0
Step D __ E
Step
A.
B.
C,
1
In this order, route tthe threaded end of the let cable (107) through the top boom (20), the
(15), and the large hole in the pec guTde rod support
Screw the threaded end of the laf cable (107) approx|mately 3/4" into the end of the selector
shaft C
113)
and fighfen, jam nut securely as shown.
Securely assemble three 3_-,1/2" pulleys (111) into the slots of the top boom C20) using three 3/8
2-3/4" bolts C99), six 3/8’ Flange Spacers (74), and three 3/8" nylock nuts (83). (Note: Loop
cable around each pulley prior to inserting it into the slot.)
Securely assemble two 3-1/2" pulleys (111) into the slots of the base (15) using two 3./’8
2-3/4" bolts (99), four 3/8"" Flange Spacers (74), and two 3/8" nylock nuts (B3). (Note: Loop
cable around each pulley prior to inserting if into the slot.)
Secu’rely tighten the bolts of the pec guide rod support (43) and fop boom (ZO) connect’ion at
time. (Note: Center the pec guide rod support horizantally and vertically before tightening.
Apply two 1" x 1" gll~des (60). to the floating pulley (30), as shown.
Securely assemble one 4-1/Z" pulle~’ (.110) to the flpafing pulley stop (32) using one 3/’8 x 2-.3/4"
bolt (99~), two 3/8" flange spacers (.74), and one 3/8" nylock
Securely assemble one 4-1/2" pulley (110).to the floofin
9
pulley (30) using one 3/B x 2" half
(100), two 3/8" washers C78), and one 3/8 nylock nut ~83). Loop cable around pulley and place the
floating pulley (30) onto the floating pulley stop (32).
18