Filter
Top Products
I
Step 12
A.
Insert two plate bushings ~102~ |nto She °’ParaBody" side of each of sixty weight plates (677 as
shown.
B. Insert one guide rod (28~ through one weight stock cushion (109~ and into each of the large
hales in the base C15), the leg welghf stock base ~IB~, and the press weight stack press (1~ as shown.
C.
Ccrefully slide twen~ weight plates C67) onto eachset of guide rods (28~ with the "Pcr,=Body"
side up and the cer=ter key-hole facing outward,
Securely assemble one selector shaft (113~ to one head plcte Cl17~ using one 3/8" black look
D. I~ x 1-1/4" bolt-(1Z2~. Repeat this s,~ep for the other two
washer (86), .cz.n_d_..on~,e,~/~,-r..hi E HEAD PLATE SHOULD BE ON TOP)
head plates. (NO/I:.: zrt~ == .......
IN TH
E.
’Carefully slide one head plate assembly over each set of guide rods and onto each top weight
plate as shown.
F.
Insert one cap plug ~57~ into each guide rod (2B~.
G.
Apply one weight s~ack label (11B~ onto each weight plate ~67~ as shown. Labels 1 through 2.0
should be applied from top to bottom of the weight stack and close to ,the key-hole.
15