Filter
Top Products
FIGURE 1
4
STEP 1
• SECURELY assemble the STACK GUARD (9) to the BASE (1) using two 1/2 X 4” BOLTS (68), two 1/2 WASHERS (55), and two 1/2”
LOC K NUTS (53) as shown in FIGURE 1.
• Center one 4 X 14" NON SKID STRIP (47) on the BASE (1) as shown in FIGURE 1.
53
55
47
13
9
1
68 1/2 X 4”
• Assemble the SWIVEL PULLEY BRACKET (13) to the shoulder bolt on the BASE (1) using one 1/2" LOW HEIGHT LOCKNUT
(54) as shown in FIGURE 1. (NOTE: Securely tighten, then back nut off 1/4 turn to allow the SWIVEL PULLEY BRACKET (13)
to rotate freely.)
54 LOW HEIGHT
70
• Assemble two 2-1/2 X 5-1/2" NON SKID STRIP (70) on the BASE (1) as shown in FIGURE 1.