Filter
Top Products
16
FIGURE 21
STEP 21
• Route the SECONDARY CABLE (32) around the pulleys and retaining clips. (NOTE: The bolt holding pulley and retaining clip may need
to be loosened to align cable retaining clip with cable.)
• SECURELY assemble one 3-1/2” PULLEY (34) to the angle on the BENCH FRAME (2) using one 3/8 X 2” BOLT (64), one 3/8” WASHER
(51), one 2-3/8” CABLE RETAINING CLIP (49), one 3/8” LOCK WASHER (52) and one 3/8” LOCK NUT (50) as shown in FIGURE 21.
(Position Pulley so that the Bolt is in the middle of the slot.)
• SECURELY assemble one 3-1/2” PULLEY (34) to the angle on the PRESS ARM ADJUST (7) using one 3/8 X 2” BOLT (64), one 3/8”
WASHER (51), one 2-3/8” CABLE RETAINING CLIP (49), one 3/8” LOCK WASHER (52) and one 3/8” LOCK NUT (50) as shown in
FIGURE 21.
34
49
51
52 3/8” LOCK WASHER
32
50
2
64 3/8 X 2”
7
52 3/8” LOCK WASHER