Filter
Top Products
19
• Assemble the metal ball end of the SECONDARY CABLE (32) to the CLEVIS (43) as shown in FIGURE 24.
• Route the CABLE (32) around the pulley and SECURE the CLEVIS (43) to the tab on the LEG CURL/EXTENSION (8) using one 3/8 X
1-1/4” BOLT (63) and one 3/8” LOCK NUT (50). (NOTE: Do not overtighten! Clevis should rotate freely.)
• SECURELY assemble one 3-1/2” PULLEY (34) to the LEG SUPPORT (4) using one 3/8 X 3” BOLT (66), one 2-3/8” CABLE RETAINING
CLIP (49), two 1/2” SPACERS (59) and one 3/8” LOCK NUT (50) as shown in FIGURE 24.
• Route ball end of CABLE (32) through the slot in BENCH FRAME (2) as shown in FIGURE 24.
32
43
50
8
4
50
59
34
49
3/8 X 1-1/4” 63
2
0
1
2
345
6
1/2 1/2 1/2 1/2 1/2 1/2
FIGURE 24
STEP 24
3/8 X 3” 66
DO NOT
OVERTIGHTEN!