Filter
Top Products
16
TROUBLESHOOTING
Problem Cause and Remedy
Does not start even after pressing
the OFF/ON button.
The unit will not operate at all.
• The power plug is not securely inserted into the outlet.
In this case, securely insert the power plug into the outlet.
(See page 7)
• The lock switch key is in the “lock” position. In this case,
set it to the “open” position. (See page 7)
• The main power switch is off. In this case, turn the main
power switch on. (See page 7)
• After pressing OFF/ON button Pre-Set Program button or
the Manual Control button has not been pushed.
The unit stopped operation and all
the lamps on the control panel flashed.
• An extremely heavy load was applied. Reset the flashing
lights by pressing the OFF/ON button. (See page 10)
Operation of the unit moves fast then slow. • Your bodyweight shifted to one side of the unit. Refer to
the basic posture and sit properly. (See page 9)
The tilting of the seat (left and right) is
not even.
Note: If the problem is not solved by the above remedies, immediately stop using the unit.
• Your bodyweight shifted to one side of the unit or you were
not sitting in the center of the seat. Refer to the basic
posture and sit properly. (See page 9)
Seat reclines during stop. • This occurs since the seat is designed to move in a figure
eight pattern and is not an indication of a problem.
Noise is heard during operation. • This occurs due to the design and is not an indication of a
problem.
• Immediately stop using the unit.
Unusual or periodic noise is heard during
operation.