Filter
Top Products
38
4. SYMPTOM: THE WALKING BELT IS OFF-CENTER OR SLIPS WHEN WALKED ON
a. If the walking belt has shifted to the right: Remove the
k
ey and unplug the power cord. Using a 7/32" hex key,
turn the roller adjustment bolts in the directions shown, 1/4
o
f a turn each. Be careful not to overtighten the walking
belt. Then, plug in the power cord, insert the key, and use
the treadmill for a few minutes. Repeat until the walking
belt is centered.
b. If the walking belt has shifted to the left: Remove the
key and unplug the power cord. Using Using a 7/32"
hex key, turn the roller adjustment bolts in the directions
shown, 1/4 of a turn each. Be careful not to overtighten the
walking belt. Then, plug in the power cord, insert the key,
and use the treadmill for a few minutes. Repeat until the
walking belt is centered.
c. If the walking belt slips when walked on: Remove the
key and unplug the power cord. Using Using a 7/32"
hex key, turn both roller adjustment bolts clockwise 1/4 of
a turn. When the walking belt is properly tightened, you
should be able to lift each side of the walking belt 2.5 to 5
cm (1 to 2 in.) off the walking platform. The center of the
walking belt should just touch the walking platform. Make
sure to keep the walking belt centered. Then, plug in the
power cord, insert the key, and run the treadmill for a few
minutes. Repeat until the walking belt is properly tight-
ened. Note: As you tighten the roller adjustment bolts, the
front roller will move. If the front roller stops moving, do
not further tighten the roller adjustment bolts; see
HOW TO CONTACT CUSTOMER CARE on page 2.
5. SYMPTOM: THE WALKING BELT STOPS OR THE INCLINE CANNOT BE ADJUSTED EVEN THOUGH
THE CONSOLE REMAINS LIT
a. This indicates that a controller error may have occurred. To correct the problem, turn the power switch off,
wait 5 seconds and then turn the power switch back on.
6. SYMPTOM: THE INCLINE SYSTEM DOES NOT FUNCTION PROPERLY OR THE INCLINE SYSTEM DOES
NOT APPEAR TO BE AT THE INCLINE LEVEL SHOWN IN THE MAIN DISPLAY
a. The incline system may need to be calibrated. To initiate the calibration routine, turn the power switch off,
wait 5 seconds and then turn the power switch back on. During the calibration routine, the treadmill will auto-
matically travel to the lowest incline level and then return to level.
b. If the incline system still does not function properly, see HOW TO CONTACT CUSTOMER CARE on page 2.
a
Right
b
Left
c