Filter
Top Products
30
HOW TO USE THE MAINTENANCE MODE
The console features a maintenance mode that allows
y
ou to access information and to view and change var-
ious default settings. Follow the steps below to use the
m
aintenance mode.
1. Insert the key into the console.
See GETTING STARTED on page 17.
2. Hold down the ENTER button and the CLEAR
button simultaneously for two seconds to se-
lect the maintenance mode.
When the maintenance mode is selected, the
words MAINTENANCE MODE will appear in the
main display. The word HOURS and the total
number of hours that the treadmill has been used
will then be shown.
3. Press the ENTER button to view the total dis-
tance that the walking belt has moved.
4. Press the ENTER button again and set a maxi-
mum program time.
To set a maximum program time, press the + and
– buttons beside the ENTER button. The maxi-
mum program time can be up to 90 minutes.
5. Press the ENTER button again and set the
delay time for the timeout mode.
A
ny time that the treadmill is not used for several
minutes, the console will enter a timeout mode
a
nd the words SELECT PROGRAM TO BEGIN
will appear in the main display. To set the number
of seconds before the console will enter the time-
out mode, press the + and – buttons above the
ENTER button. The delay time can be from 15 to
120 seconds.
6. Press the ENTER button again to create the
CUSTOM programs.
The words CUSTOM PROGRAM will appear in
the main display.
You can design up to three CUSTOM programs.
To select a CUSTOM program, press the + and –
buttons beside the ENTER button. When you see
the CUSTOM program you want to design (PRO-
GRAM 1, PROGRAM 2, or PROGRAM 3), press
the ENTER button.
Note: If the CUSTOM program has not yet
been defined, only two rows of indicators will
appear in the matrix.