Filter
Top Products
Press the ENTER AGE/WT button again and
delete or add TV channels.
After all valid TV channels have been stored in the
console’s memory, you can delete unwanted
channels or add other channels. To delete or add
a channel, first press the CHANNEL + and – but-
tons until the channel appears in the main display.
Next, press the + or – button above the ENTER
AGE/WT button until the words DELETE or ADD
appear in the main display. Then, select the next
channel that you want to delete or add. Repeat
this process until you have finished deleting or
adding channels.
Hold down the ENTER AGE/WT button and the
RESET button simultaneously for two seconds
to exit the maintenance mode.
To exit the maintenance mode at any time, hold
down the ENTER AGE/WT button and the RESET
button simultaneously for two seconds.
HOW TO RESET THE SERVICE DISTANCE
If the words LUBRICATE DECK appear in the main
display when the maintenance mode is selected (refer
to step 9 on page 24), follow the steps below to reset
the service distance.
Insert the key into the console.
Refer to GETTING STARTED on page 14.
Hold down the RESET button and the + and –
buttons above the ENTER AGE/WT button for
two seconds to select the technical mode of
the console.
Important: While the technical mode is se-
lected, press only the keys described below.
Press the ENTER AGE/WT button four times.
When the button is pressed four times, the word
TIME, a five-digit number, and the word HOURS
will appear in the display. Note: Do not press the
ENTER AGE/WT button too rapidly. Make sure
that you hear a tone each time you press the
button.
Press the + button beside the ENTER AGE/WT
button three times.
When the button is pressed three times, the words
SERVICE DISTANCE and a five-digit number will
appear in the main display. Press the RESET but-
ton to reset the service distance.
Press the ENTER AGE/WT button again.
Hold down the RESET button and the + and –
buttons above the ENTER AGE/WT button for
two seconds to exit the technical mode.
6
5
4
3
2
1
15
16
25