Filter
Top Products
STEP 36:
29
FIGURE 36
• SECURE the PRESS CABLE (44) and one 4-1/2” PULLEY (48) to the PRESS GUIDE ROD SUPPORT (20) using one 3/8 X 2-3/4”
BOLT (90), two 3/8” FLANGE SPACERS (69), one 2-7/8 X 2-1/4” CABLE CLIP (116) and one 3/8” LOCK NUT (82) as shown in
FIGURE 36. (NOTE: Loop the cable around the pulleys prior to inserting it into the PRESS GUIDE ROD SUPPORT.)
3/8 X 2-3/4” 90
20
82
69
48
44 PRESS CABLE
STEP 37:
PRESS 44
CABLE
50
53
• Screw the threaded end of the PRESS CABLE (44) approximately 1” into the end of the SELECTOR SHAFT (50) of the HEAD PLATE (53)
as shown in FIGURE 37.
116