Filter
Top Products
STEP 20:
FIGURE 20
20
• Slide the PRESS GUIDE ROD SUPPORT (20) and LEG GUIDE ROD SUPPORT (21) over their respective GUIDE RODS (19) and
SECURELY assemble them to the TOP BOOM (30) using two 1/2 X 3-1/4” BOLTS (91) and two 1/2” LOCK NUTS (85) as shown in
FIGURE 20.
0
1
2
3 4 5
6
1/2 1/2 1/2 1/2 1/2 1/2
STEP 21:
FIGURE 21
• Slide the 13/16” SHAFT COLLARS (78) to the top of the GUIDE ROD SUPPORTS (20,21,22) and SECURELY tighten the SHAFT
COLLARS set screws. See FIGURE 21.
• Slide the PEC GUIDE ROD SUPPORT (22) onto the GUIDE RODS (19) and SECURELY assemble the PEC GUIDE ROD SUPPORT (22)
to TOP BOOM (30) using two 3/8 X 2-3/4” BOLTS (90), four 3/8” WASHERS (80), and two 3/8” LOW HEIGHT LOCK NUTS (83). See
FIGURE 21.
3/8 X 2-3/4” 90
95 1/2 X 3-1/4”
83 3/8” LOW HEIGHT
22
78
19
20
80
21
85
21
20
19
30
30