Filter
Top Products
8
Assembly
A1
A23
A24
A2
N1
N2
N3
Figure 3
Step 1:
Connect hand pulse sensor wire-rear (A24)
to the hand pulse sensor wire-middle (A23).
Step 2:
Locate the front (A1) and rear (A2) main
frames. Connect both front and rear
frames. To secure, use six bolts (N1), six
spring washers (N2) and six washers (N3) -
make sure all holes are lined up correctly.
Note: Ensure that all wires are secure
inside tube during the entire time both
frames are being secured. Be careful not to
pinch wires.
Figure 3
D
I
A26
A25
A21
N1
N2 N3
A1
A23
Figure 4
Step 1:
Locate main support tube (D) and main
support tube cover (I). Slide main tube
cover up the main support tube.
Step 2:
Connect hand pulse sensor wire - front
(A25) coming from main support tube to
hand sensor wire - middle (A21) coming
from the main frame.
Connect power wire (A26) coming from
main support tube (D) to power wire (A23)
coming from the main frame.
Step 3:
Secure main support tube to main frame
(A1) using four bolts (N1) and four spring
washers (N2) and two washers (N3). Slide
main support tube cover down until it meets
the main frame.
Figure 4