Filter
Top Products
STEP 4 (See Diagram 4)
A.) Slide nineteen Weight Plates (#59) onto the Guide Rods (#12). Make sure the grove
on the Plates all face toward front of the machine. Insert the Selector Rod (#13) into
the center hole. It is strongly recommended to spray lubricant such as WD-40 on the
two Guide Rods to minimize friction.
B.) Slide the Selector Stem (#58) onto the two Guide Rods and the Selector Rod. Slide
the Ø 1 ¾” x 2” Rubber Bumper (#72) onto the Selector Rod. Insert a Weight
Selector Pin (#50) into the selected hole on the Plates.
C.) Place the Guide Rod Upper Frame (#11) onto the Guide Rods. Secure it with two
M10 x ¾” Allen Bolts (#80) and Ø ¾” Washers (#94).
D.) Attach each end of the Guide Rod Upper Frame to the Right and Left Upper Frames
(#4 & #18). Secure each end with one M10 x 2 1/8” Allen Bolt (#83) and Ø ¾”
Washer (#94).
11